Single Mode or Multimode Fiber? Which Should I Use?
Short answer: single-mode is for distance and multimode is for shorter runs inside a building. The two don't mix, so picking the wrong one is like putting diesel in a gas car. It might start, but you won't enjoy what happens next.
Here's how to tell them apart and how to choose.
Side by side
| Single-mode | Multimode | |
|---|---|---|
| Core size | About 9 µm (thinner than a hair, by a lot) | 50 µm or 62.5 µm |
| Light source | Lasers at 1310 / 1550 nm | VCSELs or LEDs at 850 nm |
| Distance | Kilometers, even tens of kilometers | Roughly 30 to 550 m, depending on grade and speed |
| Jacket color | Yellow | Orange (OM1/OM2), aqua (OM3/OM4), lime (OM5) |
| Grades | OS1 (indoor), OS2 (outdoor/long-haul) | OM1 to OM5 |
| Typical use | Carrier networks, FTTH, campus backbones, long links | Inside buildings, data centers, short backbones |
The thin single-mode core carries one path of light, so the signal stays clean over long distances. Multimode's wider core carries many paths at once. They arrive at slightly different times, which limits how far the signal can go.
The multimode alphabet: OM1 to OM5
| Grade | Core | Jacket color | Approx. 10 Gb/s reach | Notes |
|---|---|---|---|---|
| OM1 | 62.5 µm | Orange | 33 m | Legacy; fine for 1G, not much else |
| OM2 | 50 µm | Orange | 82 m | Legacy |
| OM3 | 50 µm | Aqua | 300 m | Laser-optimized; common baseline today |
| OM4 | 50 µm | Aqua or violet | 400 m | The go-to for new 10G/40G/100G builds |
| OM5 | 50 µm | Lime green | 400 m | Built for wavelength multiplexing (SWDM) |
Reach drops as speed goes up. At 100G, OM4 typically manages around 100 m. Always check the optic's spec sheet for the actual figure.
How to choose
- Match what's already there. Adding to an existing plant? Use whatever it runs. Nobody wants to explain a mixed closet to the next tech.
- Long run or between buildings? Go single-mode.
- Inside one building, under a few hundred meters? Multimode, usually OM4, does the job.
- Planning for the future? Single-mode has almost unlimited headroom. Single-mode optics used to cost a lot more, but the gap has narrowed, so many new builds now go single-mode everywhere.
Common mix-ups
- Patching single-mode into multimode. The link may light up and then drop errors all day. Check the jacket print.
- Mixing 50 µm and 62.5 µm multimode. Same connectors, different cores, real signal loss.
- Mismatched optics. A multimode SFP won't work on single-mode fiber, and the reverse is just as bad. The fiber and the optics have to match.
Shop the gear
- Single-mode bulk cable: indoor, outdoor, armored and drop cable
- Multimode bulk cable: indoor, outdoor and armored
- Fiber optic cable in stock
- Patch cords: single-mode, multimode LC, multimode SC and multimode ST
- Media converters for going from copper to fiber
Need a hand?
New Tech Industries has been supplying fiber, cable and network gear to installers since 1982. Tell us the distance, the speed and what's on each end, and we'll point you to the right cable and patch cords. Browse fiber products at newtechindustries.com or give us a call.