The Tempo 468-G Wiremap Tester checks four-pair voice and data links terminated in standard 8-position RJ45 jacks. LEDs light in sequence for each wire, which makes miswires far easier to spot than with simple pair checkers, and a built-in tone generator helps identify the cable at the far end.
Features:
Tests T568A, T568B (AT&T 258A/10 Base T) and USOC wiring
Finds opens, shorts, reversed and transposed pairs
Sequencing red and green LEDs for clear good/bad results
Built-in tone to identify cable at a remote location
Test starts automatically when the receiver is connected
Shielded ports test shielded and unshielded cable
Warns if connected to an active circuit without damage to the unit
Kit includes:
468T transmitter
468R receiver
Two RJ45 adapter cords
Specifications:
Tone: 850 and 950 Hz alternating
Tone output: 9 V p-p open circuit
Voltage protection: transmitter 52 VDC; receiver 52 VDC momentary
Power: one 9V battery (not included), about 2000 hours
The Tempo 468R-G is the replacement receiver unit for the 468-G Wiremap Tester. Connecting the receiver to the far end of the link starts the test automatically, and its sequencing red and green LEDs...
CABLE TRANSMISSION TESTER - SignalTEK® CT
Replaced by 156006
If you install or maintain data cabling, SignalTEK CT® allows you to generate PDF test reports that prove installed links run at Gigabit...
Klein LAN Scout Jr. 2 Cable Tester
Cable tester for data (RJ45) terminated cables and patch cords
Large backlit LCD for low lit areas displays pin to pin wiremap results
Test for Open, Short,...
Tests for continuity on RJ-11 or RJ-45 jacks or cables. LED indicators for pairs 1&2, 3&6, 4&5 and 7&8.
Tests RJ-11 and RJ-45
Cable type: UTP/STP/FTP
9 Volt Battery Reuired, Not Included
Standard CAT5e RJ45 Connectors for Telephone Cable (Pack of 10)
50 ?m gold plating on contact surfaces provides greater signal quality than the competition
Clear housing allows the operator to...
