|
Features:
-
Auto Power Off: 12 seconds after Pass/Fail results
-
Auto Power Off: 30 minutes in "Tone" mode
-
Minimum cable length for testing: 0ft
-
Maximum cable length for testing: 3000ft
-
Maximum DC cable resistance (Shield + Center Conductor): 100
ohms
-
Dimensions 3-1/4" x 2" x 1-1/4"
-
Weight: 4 oz (with battery)
|
The LAN MAPPER consists of the master unit and
eight or sixteen remote identifiers. The Port IDs are marked on the identifiers. This device is used to test LAN cable with RJ45 connectors and PHONE cable with RJ11 connectors. The device is connected to one end of the testing cable and the remote identifiers are connected to the other end of the testing cables.
There are four faults that can be tested on each pair: Overvoltage, Open, Short, Reversed pair.
By analysis, test results for each pair can help find more faults as: Crossed pair, Split pair, Transposed pair, and Double split pair.
To put tone on a cable, simply push and hold down the "TEST" button until the "TONE" LED lights. The device is now transmitting tone on the cable. The "TONE" LED will flash indicating that the tone mode is on. Tone mode will automatically shut off after approximately 30 minutes. To exit the tone mode, push the "TEST" button once. The "TONE" LED will turn off.
|
602-850
8-Way Tester |
|
|
602-860
16-Way Tester |
|
|
