Loading... Please wait...

Use Coupon 50FREE for FREE SHIPPING on $50.00 Purchases

Not Included: Cable, Racks, Cabinets, Phones, WIFI, Some Tools

Ideal R153001 NaviTEK NT Network Testing and Troubleshooting Tool

Bookmark and Share
  • Ideal NaviTEK NT Network Testing and Troubleshooting Tool
  • Image 2
Calculated at checkout
Bookmark and Share

Product Description

Ideal R153001 NaviTEK NT Network Testing and Troubleshooting Tool

Kit Content

1 x NaviTEK NT test unit, 1 x Remote unit No. 1, 4 x AA dry cell batteries (non-rechargeable), 2 x Patch cables - 30cm, Cat. 5e STP, 1 x Quick reference guide, 1 x Carry case


Performs tests for copper cabling and networks, including:
Display network configuration - IPv4 /IPv6 compatible

  • Advanced wiremap for miswires, split pairs, opens and shorts
  • Distance to opens and shorts (TDR)
  • PoE/PoE+ detection
  • Tone generator for cable tracing
  • Ping and Traceroute testing
  • Hub blink for port identification
  • DHCP client
  • Switch detection - 10/100/1000 Mb/s
  • User-exchangeable RJ45 inserts
  • Support for up to 12 wiremap remotes
  • Backlit color screen

Test Mode Selection

A test mode selection is shown on the start screen allowing users to easily choose between Auto-detect, Cable, Switch and Network.  Also in instances where switches are configured to deny any unapproved devices, the NaviTEK NT will now display LLDP/CDP port information when connected due to its passive testing mode.


Fiber Cabling Pass/Fail

The NaviTEK NT will indicate a Pass or Fail when testing fiber cabling. Clear color coded on screen indications of Pass (Green) and Fail (Red) help technicians judge optical Rx power level more easily, as well as eliminating any guess work for technicians with limited knowledge of optical levels. The Pass/Fail threshold simply needs to be defined by the user in Setup from the main network test screen.


Port & network summary info

Press the Autotest button to display summary information and allow for detailed inspection of network parameters.



VLAN detection & operation

Automatic detection of VLAN ID’s allows the user to configure NaviTEK NT for operation on a VLAN.


Ethernet utilisation

Real time display of broadcast network traffic shown as a percentage of port speed for the previous 60 minutes.


CDP/LLDP/EDP port information

Show port information using Cisco Discovery Protocol (CDP),  Link Layer Discovery Protocol (LLDP) and Extreme Discovery Protocol (EDP).



Display list of IP and MAC addresses of every device connected to the network.


Network Probe

View network illustration to verify test results of each network component.



Click the button below to add the Ideal R153001 NaviTEK NT Network Testing and Troubleshooting Tool to your EZOrder list.

You Recently Viewed...