The West Penn DA2401 is a 110 ohm cable made for AES/EBU digital audio. Low loss foam insulation and tight impedance control keep digital signals clean, and the shield is bonded to the jacket for easy stripping.
24 AWG stranded (7x32) tinned copper conductors
Low loss foam polyethylene insulation
100% aluminum polyester foil shield with 24 AWG stranded drain wire, bonded to the jacket
Nominal impedance 110 ohms, velocity of propagation 78%
West Penn D441 is a three-pair 18 AWG cable with every pair individually shielded, so three separate audio or control circuits can share one jacket without crosstalk, even on longer runs.3 twisted...
West Penn D440 gives each of its two 18 AWG pairs its own foil shield and drain, keeping the circuits isolated from each other and from outside noise. It suits longer line-level audio and control...
West Penn 452 is a miniature shielded twisted pair with stranded tinned copper, a flexible, low-capacitance choice for balanced line-level audio, rack wiring and short mic-level runs.One twisted pair...
West Penn 25751B gives you a two-pair 18 AWG stranded cable (West Penn Plenecon II, extra flexible) in a flexible plenum jacket, so it can be run in ceilings and ducts used for environmental air...
West Penn 373 carries three twisted pairs, one shielded and two unshielded, for systems that want a clean audio pair plus two pairs for data, call or control signals.Three twisted pairs of 22 AWG...
West Penn 77350 is a four-conductor media control cable that carries a shielded 22 AWG data pair and an 18 AWG power pair in one jacket, built for control-system bus wiring between touch panels,...
