This auxiliary electronic ringer operates on any analog line that provides a minimum of 40 volts 20-30 Hz AC ring voltage. Nominal 3 KHz warble provides adequate volume for business offices. The LPR-1 can be connected via screw terminals or modular RJ-11 jack. A volume control and a 7 foot modular cord are provided. No power supply is required.
Ringing from an analog line
Connect via screw terminals or modular RJ-11 jack
7 ft line cord provided
Adjustable volume control
Environmental: 0°C to 32°C (32°F to 90°F) with 5% to 95% noncondensing humidity
Maximum Sound Pressure: 92 dB SPL @ 1 meter (nominal)
Minimum Ring Voltage: 40V AC RMS @ 20-30 Hz
Connections: (2) cage clamp screw termInals (1) modular RJ-11 jack
SR-1 Viking Electronics Viking Single Line Loud Ringer.
The SR-1 will generate loud ringing from an analog ringing line or from a dry contact closure. There are 4 different ringing sounds to...
Viking SR-IP SIP Audible Ringer with Visual Ring Indication and Remote Strobe Light Control
***** Note: This unit requires technical knowledge of IP addresses to be installed. *****
The SR-IP is a...
Viking DLE-200B Phone Line Simulator
Compatible with fax machines and modem speeds up to 28.8 kbps
Precise dial tone
Switch selectable ring cadence
Provides CPC breaks after hang-up on either...
Manufacturer Discontinued
The Stinger Ringer cuts through the noise of any environment with a powerful 110 dBA. Its intense signal is transmitted in all directions and reaches every corner of an...
Stay in Compliance with the new ASME A17.1 Requirement Immediate Alarm on loss of line Compatible with all Analog Elevator or Emergency Phones Line Verification Panel with Key Switch New ASME A17...
