| #1 |
Determine the appropriate type of IR Target
for your installation. The Keystone style
pictured above is good if you want the IR in a plate on the wall or ceiling. The Plasma Proof
target is designed for use on the top of or to the
side of your TV and the panel mount is ideal if all
your equipment is behind a cabinet. The IR
Target encodes the infrared signal so it can
travel over the Category 5E cable. |
| #2 |
Run your Category 5E cable from your IR
Target to your IR hub. |
| #3 |
Your IR Hub will require power so
position that where access to power is
simple. Your IR Hub will have
either 4 or 8 outputs. These
connect to the IR Emitters. You
need one port for each device you want
remotely controlled. |
| #4 |
Connect your IR Emitter on to
the device you need controlled
remotely. You can use double
stick tape which is provided or a
dot of super glue to insure
continued operation. The emitter is
placed over the IR sensor of the
equipment. The emitter can be
either directly connected to the IR
Hub or it can be lengthened over a
Category 5E cable as well. |
