|
The 302-type connector is a molded plastic panel 16-1/4 inches high. The connector has 100 groups of 5-pin terminals that accept 3-, 4-, 5-, and 7-type protector units (ordered separately). The four tip and ring terminals are gold plated. The fifth (ground) terminal is solder plated. A sixth hole (blind) is provided for inserting designation pins.
The 302A1, B1, and E1 connectors are used to terminate outside plant cables on the ED-1A220-31 modular protector frame. When the high density modular protector frame is utilized, the 308 connector should be used to terminate outside plant cables.
The 302A4, B4, and E3 connectors are used to terminate outside plant cables and provide facilities for tie pairs to the MDF on the low profile and tall double sided protector frame. These connectors used for double sided protector frames, have a hinged mounting bracket that allows the connector panel to swing out for access to the back plane cable.
The terminal field on the rear of the connector has wire-wrap terminals. Pair identification is provided on both the front and back of the connector with pair numbers molded into the connector.
|
